Rhino

  • Rhino Vortex Bar Rubbber 400mm

    The M626 VGS Vortex Bar Rubber is a 400mm strip sold individually and designed to reduce wind noise as well as giving your roof racks additional padding and styling

    Features:

    • Available in lengths of 400mm
    • Easy to install/remove
    • Reduces wind noise
    • Provides additional padding and styling
    • Short pieces facilitate accessory fitting
    • Sold individually
    $4.00
  • Need a bit of extra height on your Heavy Duty CXB roof rack bars? This pair of spacers will give you an extra 6mm of height to work with.

    Set up is straight forward – simply insert each spacer between the leg and bar using the provided hardware and you’re all done.

    Features:

    • Adds an extra 6mm of height to your bars
    • Specifically designed for use with Rhino-Rack Heavy Duty CXB Roof Rack Systems
    • Includes 2 leg spacers
    From $10.00
  • The RLKS1 spacer blocks are used to level a 3 bar roof rack system on a vehicle such as a ute or pick up that may have rear ute posts or a canopy rack system. Attached between the Rhino-Rack 2500 leg and either a Rhino-Rack Heavy Duty or Vortex cross bar, this set of spacers will raise the cross bar 10mm in height.

    These leg height spacers have been designed for use on a support bar, set up for long loads - they are not to be used as a 2 bar system under a load bearing cross bar. Made from glass re-enforced nylon, just like our legs, they are strong and flexible.

    This kit includes:

    • 2 x 10mm Spacer Blocks
    • 2 x M6 x 32mm Bolts
    From $14.00
  • Rhino Quick Mount Hd Spacer

    The Quick Mount Heavy Spacer allows you to fit the Rhino-Rack Heavy Duty Bars to the RLT600 legs. Sold as a pair of 2. 
    Available in 5mm, 10mm, 25mm, 30mm

    From $15.00
  • Rhino Quick Mount 10mm VA spacer

    The Quick Mount Vortex Spacer (10mm) allows you to fit the Rhino-Rack Vortex Bars to the RLT600 legs. Sold as a pair of 2 which fits 1 bar.

     

     
    From $16.00
  • Rhino 100 mm Leg Height Spacer Pair

    Spacer blocks are useful to obtain a level height between all of the crossbars on your vehicle. Installation is a breeze - simply place the spacers between the leg unit and the crossbar of your roof rack until all of the crossbars have been raised to an even level.

    Each spacer is 10mm high, and this pack comes with 2 x spacers and 2 x M10 (35mm) bolts.

    Features:

    • Designed specifically to fit Rhino-Rack Heavy Duty bars.
    • Provides one bar with a 10mm increase in height.
    $17.00